Lower Guard Function - Dexter 20VCIS3-190BL.1 Manual De Instrucciones

2. SAFETY INSTRUCTIONS
B. When blade is binding, or when interrupting a cut for any
reason, release the trigger and hold the saw motionless in
the material until the blade comes to a complete stop. Never
attempt to remove the saw from the work or pull the saw
backward while the blade is in motion or kickback may occur.
Investigate and take corrective actions to eliminate the cause of blade
binding.
C. When restarting a saw in the workpiece, centre the saw blade
in the kerf so that the saw teeth are not engaged into the
material. If a saw blade binds, it may walk up or kickback from the
workpiece as the saw is restarted.
D. Support large panels to minimise the risk of blade pinching and
kickback. Large panels tend to sag under their own weight. Supports
must be placed under the panel on both sides, near the line of cut and
near the edge of the panel.
E. Do not use dull or damaged blades. Unsharpened or improperly set
blades produce narrow kerf causing excessive friction, blade binding
and kickback.
F. Blade depth and bevel adjusting locking levers must be tight
and secure before making the cut. If blade adjustment shifts while
cutting, it may cause binding and kickback.
G. Use extra caution when sawing into existing walls or other
blind areas. The protruding blade may cut objects that can cause
kickback.

LOWER GUARD FUNCTION

A. Check the lower guard for proper closing before each use. Do
not operate the saw if the lower guard does not move freely
and close instantly. Never clamp or tie the lower guard into the
open position. If the saw is accidentally dropped, the lower guard may
be bent. Raise the lower guard with the retracting handle and make
sure it moves freely and does not touch the blade or any other part, in
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
371