Attaching.the.src-System - SCHUBERTH SRC‑SYSTEM S2 Manual De Instrucciones

.1... P ull.out.the.antenna.connector.(marked.with.a.red.tag).which.is.tucked.inside.
the.back.rim.of.the.helmet.
Antenna tag visible
2... O n.the.SRC.collar.open.the.two.fasteners.on.the.
antenna.connector.and.remove.the.protective.
plastic.cover.
3... O n.the.helmet.remove.the.rubber.protector.
from.the.antenna.connector.
4... A lign.the.two.connector.heads.and.snap.the.two.
fasteners.back.into.place.to.lock.the.connector.
in.a.closed.position..
34
MAN00097 QG SRC-S2_C3 J 009.indd 34
Antenna connector
pulled out
A. B.
A.
antenna-plug (helmet) unsealed (with
B. arrows)
5... T he.antenna.connector.can.now.be.safely.
stowed.away.inside.the.antenna.connector.
pocket.on.the.center.of.the.SRC-System™.
6.3 ATTACHING THE SRC‑SYSTEM ™
1... M ake.sure.to.place.the.speaker.cords.inside.the.helmet,.and.then.secure.the.
SRC-System™.into.place.
2... S lide.and.insert.the.pin.located.at.the.edge.of.the.control.panel.into.its.
corresponding.indentation.on.the.helmet.and.close.the.snap.button.
Pin
3... I nsert.the.other.pin.on.the.opposite.side.of.the.Acoustic.Collar.into.place.and.
close.the.second.snap.button.
4... P ush.and.insert.the.Acoustic.Collar.starting.from.the.center.area.to.the.back.of.
the.helmet.area..Do.the.same.for.the.remaining.parts.to.secure.the.Acoustic.
Collar.into.place.
5... M ake.sure.that.both.snap.buttons.remain.fastened,.and.that.the.microphone.
boom.is.located.on.the.inner.side.of.your.helmet.(between.the.SRC-System™.
and.the.inner.padding.of.the.helmet).
7/18/12 5:38 PM