Making.intercom.calls; Receiving.intercom.calls; Voice.connect.feature.(Vox) - SCHUBERTH SRC‑SYSTEM S2 Manual De Instrucciones

9.4b. THREE‑WAY INTERCOM
The.SRC-System™.offers.three-way.intercom.conference.connectivity.as.follows:
Use Channel "A"
Rider "2"
In.this.configuration.Rider."1".is.paired.to.Rider."2".and.to.Rider."3".
IMPORTANT: Since Rider "1" uses two Bluetooth® connections during the conference
mode, Rider "1" will be disconnected from the mobile phone or GPS device until the
conference mode ends. Then, Rider "1" will automatically re-connect to his mobile
phone or GPS. Riders "2" and "3" remain connected to their mobile phones or GPS
devices during the 3-way intercom call.
Pairing.three.SRC-System™.headsets.is.achieved.by.simply.repeating.the.procedure.in.
the.above.section.9.4a.with.a.third.SRC-System™.headset.(in.a.different.CHANNEL).
1..Pair.your.SRC-System™.with.the.second.SRC-System™.as.described.in.
section.9.4a.(Using.CHANNEL."A").
2..Pair.your.SRC-System™.with.the.third.SRC-System™.as.described.in.
section.9.4a.(Using.CHANNEL."B")
42
MAN00097 QG SRC-S2_C3 J 009.indd 42
Use Channel "B"
Rider "3"
Rider "1"
9.5 MAKING INTERCOM CALLS
There.are.two.ways.to.start.an.Intercom.call.with.headsets.that.are.paired.to.your.
SRC-System™.(make.sure.you.are.in.Standby.mode):
VOICE CONNECT (VOX):
Preferred for relatively brief conversations as it takes the
channel into standby mode after 30 seconds of silence
Start talking loudly
Once.you.start.talking.loudly,.an.Intercom.call.will.be.
established.with.both.paired.headsets,.CHANNEL."A".
and.CHANNEL."B".(if.both.are.available)..
The.Intercom.call.will.stay.on.until.all.participants.
remain.silent.for.30.seconds..(Applicable.for.2-way.
communication)
NOTE: While the Intercom is on, the Redial and Voice Dial functions will be disabled.
9.6 RECEIVING INTERCOM CALLS
When.a.paired.headset.calls.you.via.intercom,.the.call.will.begin.almost.instantly.
NOTE: The headsets preset priority modes have been set in a way to avoid incoming
intercom calls from interrupting mobile phone calls and GPS instructions in progress.
In such case the intercom caller will hear a busy signal and you will hear two beeps,
indicating that an intercom caller is trying to page you. (see section 4.6 for details on
audio priorities of paired devices).
9.7 VOICE CONNECT FEATURE (VOX)
The.SRC-System™.also.offers.VOX.technology.for.safe.and.hands-free.operation.
of.some.key.functions.
The.VOX.feature.can.be.customized.to.adjust.its.sensitivity.level..You.can.choose.
between.'Regular'.(default),.'Low'.and.'High'.VOX.sensitivity..If.you.experience.
difficulty.starting.a.conversation.using.VOX,.change.the.setting.to.'High'.via.the.
PC.software.(see.section.4.3).or.directly.on.your.SRC-System™.headset.via.the.
Settings Customization Menu.(see.Section.4.4).
CHANNEL BUTTON
CONNECT:
Preferred for extended
conversations as it leaves the
channel open and active
Tap CHANNEL "A" or "B"
Button.once.to.add.or.
remove.the.other.headset.
from.an.Intercom.call.
7/18/12 5:38 PM