RIDGID R48607 Manual Del Operador página 28

OPERATION
NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figures 39 - 40.
To nest pieces of crown molding less than 3-1/2 in. tall:
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right.
 Lay the crown molding on the saw with its bottom edge
resting at a natural angle flush against the fence and its
top edge resting flush against the miter table, this is called
"nesting".
 Nest and secure the crown molding against miter fence
using a spring clamp and hold crown molding securely.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.
 Slowly lower the blade into and through the crown molding.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of the crown molding
and removing the crown molding from the miter table.
FIXED MITER
FENCE
CROWN MOLDING NESTED AGAINST
FRONT FACING MITER FENCE
SPRING
CLAMP
MOLDING
28 - English
CLAMP
BOTTOM EDGE AGAINST FENCE =
RIGHT SIDE, INSIDE CORNER
LEFT SIDE, OUTSIDE CORNER
MITER
TABLE
Fig. 39
SLIDING MITER
FENCE
Fig. 40