Assembly - RIDGID R48607 Manual Del Operador

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully lift saw from the carton by the carrying handle
and the saw base, and place it on a level work surface.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 This saw has been shipped with the saw arm secured in
the down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
the lock pin.
WARNING:
The saw arm is spring loaded. Hold the handle
down to prevent saw arm from snapping up when
cutting the tie-wrap. Failure to do so could result
in possible serious injury.
 Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After assembling
it, check for accuracy. If shipping has influenced the settings,
refer to specific procedures explained in this manual.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the tool when assembling parts.
WARNING:
Do not start the compound miter saw without check-
ing for interference between the blade and the miter
fence. Damage could result to the blade if it strikes
the miter fence during operation of the saw.
WARNING:
This saw can tip over if the saw head is released sud-
denly and the saw is not secured to a work surface.
ALWAYS secure this saw to a stable work surface
before any use to avoid serious personal injury.
BASE
12 - English
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
MOUNTING
SURFACE
Fig. 8