Tabla de contenido
Publicidad
12
4.2 Plunge cutting without pilot drilling
The base runner must be in the front position for plunge cuts
in timber materials (basic setting).
Place saw on the front edge of the runner. Set saw to maximum
no. of strokes and pendulum stroke setting 3 and start the
plunge cut into the workpiece.
4.3 Metalworking
The following precautions are to be taken when processing
metals for safety reasons:
- connect a residual current operated device in series before
the tool,
- connect tool to a suitable dust extractor,
- clean tool regularly of dust accumulations in the motor
housing.
5
Maintenance and care
Any maintenance or repair work requiring the
motor housing to be opened may only be carried out by an
authorised service workshop. Maintenance or repair work
carried out by an unauthorised person can lead to the wrong
connection of the power leads or other components, which in
turn can lead to accidents with serious consequences.
Always remove the plug from the mains supply
socket before carrying out any work on the machine!
Always keep the machine and the ventilation slots clean.
6
Accessories, tools
For safety reasons, only use original FESTOOL
accessories and tools!
The accessory and tool order number can be found in your
FESTOOL catalogue or on the Internet under „www.festool.
com“.
6.1 Festool guide system FS
The use of the Festool guide system FS facilitates the
production of straight and precise cuts, particularly with
material thicknesses up to 20 mm.
The jigsaw is hereby placed in a guide stop (11.1) and guided
along the guide rail in this.
The guide stop has two adjustable limit stops (11.2) for a
setting free from play.
6.2 Parallel guide
Use the parallel guide to guide the jigsaw parallel to the
workpiece edge.
The parallel guide can be fitted on both sides of the base
runner:
- Slide clamping clip (12.2) onto the base runner from the
front,
- insert parallel guide (12.3) through the clamping clip from
the side to the desired position.
- Tighten rotary knob (12.1).
6.3 Circle cutter
The circle cutter can be used to produce circular cuts with a
diameter between 120 mm and 720 mm.
The circle cutter can be fitted on both sides of the base runner:
- Slide clamping clip (12.2) onto the base runner from the
front,
- insert circle cutter (12.5) through the clamping clip from the
side to the desired position.
- Tighten rotary knob (12.1).
- Insert circle tip (12.4) in the rear bore hole of the circle
cutter.
Publicidad
Tabla de contenido
