Adjusting The Cutting Angle; Dust Extraction - Festool CSC SYS 50 EBI Manual De Instrucciones

English
9.6

Adjusting the cutting angle

CAUTION
Risk of crushing
When adjusting the cutting angle, the extrac­
tion channel also moves.
► Do not place hands or objects between the
extraction channel and sliding table.
Adjust the cutting angle using the control mod­
ule.
► Press the angle button [2-1].
► Set the desired angle on the dial [2-4] with­
in ten seconds.
To end setting mode early, before ten sec­
onds have passed: Press the angle button.
Adjusting the cutting angle in tenths:
Press the dial while turning it.
9.7 Calibrating the cutting angle
If the saw no longer cuts correctly at the cutting
angle that has been entered:
► Calibrate the cutting angle using the assis­
tant on the control module.
9.8 Favourites
Four commonly used combinations of cutting
height and cutting angle can be saved as fa­
vourites. A fifth favourite "P", which cannot be
changed, is the parked position. This is only
shown if the Systainer hood cannot be put on in
the current position.
Selecting a favourite
► Select a pair of favourites [2-11] on the
main screen with the dial.
► Press and hold the dial until the saw blade
position has been fully reached.
Saving favourites
► Set the desired combination of cutting
height and cutting angle.
► Press the angle button and height button at
the same time.
► Select the required favourite position [2-11]
with the dial.
► Confirm your selection by pressing the dial.
34
9.9 Spacer wedge
WARNING
Risk of injury
► Switch the power tool off at the main
switch and remove the battery pack from
the power tool before performing any work
on the power tool.
WARNING
Risk of injury
► Never work without a spacer wedge.
Spacer wedge with guard [1-12]
Where possible, always use the spacer wedge
with guard.
Non-through cutting spacer wedge [1-11]
For hidden cuts or grooves.
Removing the spacer wedge, option 1 [4A]
► Move the saw blade to the parked posi­
tion with the control module (select favour­
ite "P").
Press a hex key [1-10] into the opening
►
on the type plate, hold it there and pull the
spacer wedge upwards to remove it.
Place the hex key into the holder [1-10]
►
provided again.
Removing the spacer wedge, option 2 [4B]
► Remove the cover plate (see section 9.16).
► Press and hold the spacer wedge locking
mechanism and pull the spacer wedge up­
wards to remove it.
► Fit the cover plate again.
Fitting the spacer wedge [4C]
► Push the spacer wedge in from above until
it engages. WARNING! Risk of injury! Check
that the spacer wedge has engaged proper­
ly.

9.10 Dust extraction

WARNING
Health hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► When sawing carcinogenic materials, al­
ways connect a suitable extraction mobile
in accordance with national regulations. Do
not use the chip collection bag.