Before Use; Product Assembly - cecotec PerfectCountry Manual De Instrucciones

3. BEFORE USE

1. Take the product out of the box.
2. Remove all packaging materials.
3. Clean plates, fat drip tray and the grill cover with a soft, dampened cloth.
4. Dry them with a cloth or paper towel.
5. Operate the device at maximum temperature for 3-5 minutes without food..
Note: Smoke might be observed during fi rst use due to residual wastes from manufacture.
Make sure the grid and the fat-drip tray are clean and dry before operating.

4. PRODUCT ASSEMBLY

1. Introduce the support tubes in the holes on the grill unit's bracket. There is a fi xing pin
at the end of the support tube, align it with the slot on the grill unit bracket's lower part
and push it until fi tted into place. A click will indicate it has been properly assembled.
2. Use the food tray holders to assemble the food tray.
3. Install the fat drip tray in the grill holder, and then assemble the grill holder to the rest of
the unit.
4. Place the grill plate in the grill holder. Insert the temperature regulator set in the
connector and lower the grill plate until fi tted into the grill holder. The device must be
disconnected from the power supply while assembling.
ENGLISH
PERFECTCOUNTRY BBQ 15