Plan Vent System - Maytag MGD5700TQ Manual De Uso

Choose your exhaust installation type
Recommended exhaust installations
Typical installations vent the dryer from the rear of the dryer. Other installations are possible.
A
A. Dryer
B. Elbow
C. Wall G. Vent length necessary to connect elbows
D. Exhaust hood H. Exhaust outlet
Standard exhaust installation with rigid metal or flexible metal vent
10
B
C
D
E
F
G
B
H
E. Clamps
F. Rigid metal or flexible metal vent

PLAN VENT SYSTEM

Alternate installations for close clearances
Venting systems come in many varieties. Select the type best for your installation. Two close-
clearance installations are shown. Refer to the manufacturer's instructions.
NOTE: The following kits for close clearance alternate installations are available for purchase.
Please see the "Assistance or Service" section of this manual to order.
Over-the-Top Installation:
Part Number 4396028
Periscope Installation (For use with dryer vent to wall vent mismatch):
Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch
Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch
Part Number 4396014 - 29" (73.66 cm) to 50" (127 cm) mismatch
Special provisions for mobile home installations
The exhaust vent must be securely fastened to a noncombustible portion of the mobile home
structure and must not terminate beneath the mobile home. Terminate the exhaust vent
outside.
A B
A. Over-the-top installation (also available with one offset elbow)
B. Periscope installation