Festool BS 75 Instrucciones De Servicio página 9

ning it to the left.
At the time of fi xing, ensure that the leaf spring
stud touches the belt housing.
The dust extraction system will continue to
function effectively as long as the bag is emp-
tied in good time.
For working with the protection of the environ-
ment in mind it is advisable to use the Festool
dust extraction system.
The connecting socket from the suction hose
can be connected using the adapter (4.4) which
is supplied as standard.
4.6 Stationary work on types BS 75/
BS 75 E
(accessories type BS 75 E - Set)
When assembling the stationary support make
sure that the straight sides of the feet (5.2) are
pointing inwards towards each other.
In order to be able to work safely, the feet must
be fastened to the supporting surface using
screw clamps.
The guide (accessories/5.1) can be tilted up to
45° according to scale for sanding of bevels.
5 Maintenance and care
When the graphite coating on the pad lining
(3.3) is heavily worn this has to be replaced.
To do this the 3 cheese-head screws (3.1) are
loosened and the strip (3.2) removed.
A sanding support for rough work at high re-
moval rates is available.
The belt sander requires practically no main-
tenance.
The lubrication for the antifriction bearings and
gears is designed to last for the service life of
the machine.
It is advisable to clean the air intake and outlet
ports and the dust suction and extraction chan-
nel occasionally with compressed air while the
sander is running and at standstill.
This will prevent the openings from becoming
clogged with dust.
The special carbon brushes only wear down to
a minimum length.
Thereafter the power cuts out automatically
and the sander comes to a stop.
The motor housing may only be opened by an
authorised Festool service workshop, since spe-
cialist knowledge is required for assembly.
6 Accessories
The accessory and tool order number can be
found in your Festool catalogue or on the In-
ternet under "www.festool.com".
Sanding belts
- Resin-bonded X-cloth belts:
for fi nest wood sanding, machining of non-
ferrous and light metals, hardboards, iron and
sheet steel, deburring metals.
- Combination belts:
for removing paint and remains of concrete,
sanding plaster surfaces.
7 Warranty
Our equipment is under warranty for at least 12
months with regard to material or production
faults in accordance with national legislation.
In the EU countries, the warranty period is 24
months (an invoice or delivery note is required
as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or
any fault acknowledged at the time of purchase,
is not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before
being sent back to the suppliers or to an au-
thorised Festool customer support work shop.
Store the operating instructions, safety notes,
spare parts list and proof of purchase in a safe
place.
In addition, the manufacturer's current warran-
ty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.
9