What Do I Do, If - Fagor CAT 40 NG Instrucciones De Uso

GB
5.
Now screw the cleaned outlet valve back
onto the steam valve using the measu-
ring spoon P. Fig 51
6.
Then again place the frothing unit onto
the steam valve and lock. Fig.52
Caution, protection of the appliance! A
clogged steam valve can damage the
appliance!
If the steam valve still does not let
through any steam or hot water
following cleaning of the outlet valve, the
device must be descaled. Corresponding
information can be found in the chapter
"Starting the descaling programme".

16 What do I do, if ...

• ... coffee-making is interrupted and
the "Fill water tank" indicator (Fig. 3,
i) flashes?
– The water tank is empty. Fill the
water tank and press the
the key again.
– The water tank is not properly
inserted. Check that the water tank
is properly seated.
– The coffee is ground too finely.
Clean the coffee-making unit and
adjust the grinding texture.
• ... the coffee machine does not oper-
ate, and the "Empty grounds con-
tainer" indicator (Fig. 3, h)
– Container is full: Empty container
and clean thoroughly; see „Emptying
the Coffee Grounds Container"
• ... the coffee machine does not oper-
ate, and all 5 indicator lights Coffee
Quantity and
ing?
– The coffee-making unit is blocked or
overfilled. Refer to „Cleaning the
Coffee-making Unit". Completely
remove any encrusted coffee
remains from the coffee-making unit.
– Reduce the amount of ground cof-
fee spooned in.
– In powder coffee mode, fill in max. 1
measuring spoon of coffee powder.
– Set a small coffee quantity; see
„Changing and Saving the Coffee
Quantity".
– Check ejector.
48
key or
flashes?
or are flash-
•...the coffee machine does not operate
and humming noise is to hear, all 3 cup
size indicator are flashing.
- Brewing unit is blocked.
- Remove the brewing unit and loosen
the brewing unit using the tool
function of the measuring spoon
page 49.
• ... "Clean" key (Fig. 3, k)
flashing?
– Number of coffees dispensed
necessitates cleaning: Run cleaning
program; see „Running the Cleaning
Program".
• ... the cleaning program cannot be
started?
– Turn the bean container to the pow-
der setting, then start the cleaning
program.
• ... "Descale" key (Fig. 3, j)
flashing?
– Number of coffees dispensed
necessitates descaling: Carry out
descaling: see „Running the
Descaling Program".
• ... the espresso/coffee is not hot
enough?
– Preheat the cups with hot water.
– Increase coffee temperature; see
„Setting the Coffee Temperature".
• ... the espresso/coffee is too weak?
– Not enough ground coffee. Increase
the amount of grou nd coffee, max. 2
measuring spoons.
– The coffee bean container is empty.
Add coffee beans.
– The coffee quantity is set too low.
Increase the coffee quantity, see
„Changing and Saving the Coffee
Quantity".
– The grinding texture is set too
coarse. Set the grinding texture to a
finer grade, see „Setting the
Grinding Texture".
- Check the grinding ring.
- Try another type of coffee.
• ...the crema is too weak?
– Use fresh water.
– Use fresh beans or fresh coffee
powder.
P. see
is
is