Installation Instructions - Westfalia 314 219 Instrucciones De Montaje

Installation instructions:

1.) Lift up the cargo space floor. Take out the spare wheel and tool kit. Remove the rear bumper.
2.) Drill the following holes on the centre marks:
4 holes ø 19 mm in the rear panel (only the outer plate)
3 holes ø 14 mm in the base plate.
Drill 1 hole ø 18 in the rear panel (the outer plate) for the cable.
The centre mark is provided.
3.) Place plate pos.2 in the recess for the spare wheel, place the hitch pos. 1 against the rear panel
from outside and loosely screw together with the plate through "a" with the M 10x110 hexagon bolt
and spacer tubes.
4.) Loosely screw bracket pos. 3 to the hitch pos. 1 through "b" and with the M 10x35 hexagon bolts
through "c" to the spare wheel recess (plate pos.2).
5.) Through "d" loosely screw the plate pos.2 to the cargo space floor with the M 8 x 25 hexagon bolts.
6.) Cut out part of the bumper for the coupling ball and the socket according to the markings provided
(inside of bumper).
7.) Align the towing bracket and tighten all the bolts evenly.
Tightening torque:
Tightening torque:
8.) Place the spare wheel and tool kit in the vehicle, fold down the cargo space floor and fasten the
bumper again.
Note: Please contact your local Opel dealer to find out whether any modifications
have to be made to the vehicle (cooling system, suspension) when a towing
bracket is mounted.
12 12
M 8 Strength class 8.8
M 10 Strength class 8.8
20 Nm
40 Nm
Subject to alteration.