Saivod lavasciuga 1000 Instruccionespara El Empleo página 23

INSTRUCTIONS FOR THE DRYER The machine has a water film system which condenses the steam produced during ghe
drying cycle and then discharged through the normal drain system. N.B.: The water tap should be open and the drain pipe in
the correct position during the drying cycle. During the drying operation, the glass door may become hot. Please don't touch it.
1 - LED (machine operating)
2 - Program dial
3 - Timer dial
4 -Thermostat dial
5 - Stop button ON
6 - Extra rinse button
MAXIMUM LOAD FOR THE DRYING CYCLE For best drying results keep to the following laundry loads: - maximum of 2,5 kg.
for resistant materials (2 kg. of heavy and large items) - 1,5 kg. for mixed and synthetic fabrics The above loads will ensure that
the load moves freely in the drum and prevent excessing creasing while ensuring efficient and uniform driving
N.B. This washing machine with dryer may only be used for laundry that has previously been spun dry after a wash cycle. HOW
TO SELECT THE DRYING CYCLE The machine has two drying cycles with different temperatures, a higher temperature for
the programs for resistant materials and a lower temperature for the delicate programs (synthetic fabrics). To select the drying
program required, proceed as follow:
1) Do not press push-button 8 which excludes the spin drying cycle as otherwise the machine will not dry
2) Press the "Half load" push button (7)
3) Set dial 3 to the time required for the drying action required. Note that after the wash and spinning cycles the timer dial will
return to the stop position. If the drying program has been set the drying cycle will start at that moment, if not the machine will
stop after the wash cycle.
DEGREE OF DRYING This is indicated on the circumference of the drying program dial 3. Different degrees of drying may be
selected as follows:
- humidity residue of approx. 15%, ideal for ironing set the dial at 60'
- humidity residue of approx. 7 similar to that of laundry when removed from a wardrobe - set the dial at 80'
- extremely dry with humidity almost at zero - set the dial at 120'
HOW TO SET DRYING PROGRAMS BY HAND To dry laundry which has just been washed in a washer, first check the load
in the washer drum and remove excess laundry as indicated in the paragraph "MAXIMUM LOAD FOR THE DRYING CYCLE".
Selected the degree of drying required by rotating the dial 3 m a clockwise direction to one of the position indicated in the
paragraph "DEGREE O DRYING" set the wash program dial 2 on one of the following two positions:
- Spinning cycle- program 5 - for drying resistant materials =
- Drain program 10 - for drying synthetic fibres
(DO NOT MACHINE DRY WOOLLEN ITEMS)
AUTOMATIC WASH/DRYING CYCLE
Load the laundry into the machine as indicated in the paragraph "MAXIMUM LOAD FOR THE DRYING CYCLE", ensure that
the push-button for excluding the spinning cycle 8, has not been pressed.
Set the wash program dial 2 to the program required, set dial 3 to the drying time according to the degree of humidity required.
Start the machine which will continue to the drying cycle automatically when the wash cycle selected has been completed.
SM826
OFF
1/2
7 - Half load 12
8 - Push-button to exclude spinning cycle
9 - Stop push-button water
10 - Spinning cycle push-button 500/800/1000 rpm
11 - Detergent compartment
Energic Drying
= Delicate Drying
Press the "Half load" push button (7)
23