tau K892M Guía Para La Instalación página 10

Ocultar thumbs Ver también para K892M:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

cancelled;
5_ repeat the procedure from point 1 using button P2 to cancel all the associated radio control devices;
6_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
ATTENTION: TO memorise a code on a new type of remote control unit (e.g.: from dip-switch to
rolling code or vice-versa) both channels must be cancelled.
LED - DL7
Led DL7, as well as the normal radio control programming signals, also indicates any errors with a
series of pre-set flashes:
5 flashes:
no encoder signal;
Check wiring, check encoder by means of TEST-ENCODER (optional);
6 flashes:
presence of obstacle (after 3 failed attempts at closure);
Ensure absence of obstacles along the door travel, and ensure smooth movement;
quick flashing:
work time (stroke) SETUP procedure.
The display of multiple errors is shown with a pause of 2 seconds between one message and the next.
The error remains on display until a new complete manoeuvre (open and close) is performed by the
automation.
In the event of 3 consecutive activations (during the same closing manoeuvre) of the encoder (obstacle
detection), the control unit opens completely on the next manoeuvre. To reset, the automation must
complete a manoeuvre (opening and then closing); otherwise the end stop search process will be re-
peated after each activation of the encoder.
9. MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
The automation does not start
a_ Check there is 230Vac power supply with the multimeter;
b_ Check that the NC contacts of the card are actually normally closed (6 green LEDs on);
c_ Check that the fuses are intact with the multimeter;
The radio control has very little range
a_ Connect the radio aerial to the terminals of the receiver card and not to terminals 7-8 of the
control card (for frequency 433,92 MHz);
b_ Check that the ground and the aerial signal connections have not been inverted;
c_ Do not make joints to increase the length of the aerial wire;
d_ Do not install the aerial in a low position or behind walls or pillars;
e_ Check the state of the radio control batteries.
The motors function in reverse
a_ Invert the motor connections on the terminal block (terminals 19 and 21 for motor 1; terminals
22 and 24 for motor 2);
10. GUARANTEE: GENERAL CONDITIONS
TAU guarantees this product for a period of 24 months from the date of purchase (as proved by the sales
document, receipt or invoice).
This guarantee covers the repair or replacement at TAU's expense (ex-works TAU: packing and transport at
the customer's expense) of parts that TAU recognises as being faulty as regards workmanship or materials.
For visits to the customer's facilities, also during the guarantee period, a "Call-out fee" will be charged for
travelling expenses and labour costs.
The guarantee does not cover the following cases:
If the fault was caused by an installation that was not performed according to the instructions
provided by the company inside the product pack.
If original TAU spare parts were not used to install the product.
If the damage was caused by an Act of God, tampering, overvoltage, incorrect power supply,
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

S-200k892m

Tabla de contenido