Listening To Fm And Am Broadcasts; Tuning In To A Station; Presetting Stations - JVC UX-H35 Serie Manual De Instrucciones

Listening to FM and AM Broadcasts

Tuning in to a Station

1
Press TUNER (or BAND
TUNER on the unit) to select
the band.
The unit automatically turns on and
tunes in to the previously received
station—either FM or AM.
• Each time you press the button, the
band alternates between FM and AM.
2
Press and hold ¢ or
4 for more than 1
second.
The unit starts searching for
stations and stops when a station of sufficient
signal strength is tuned in.
• If a program is broadcast in stereo, the
STEREO indicator lights up.
To stop searching, press ¢ or 4.
When you press ¢ or 4 briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to
receive or noisy, press FM MODE so that
the MONO indicator lights up on the
display. Reception will improve.
To restore the stereo effect, press FM MODE again
so that the MONO indicator goes off. In stereo mode,
you can hear stereo sound when a stereo program is
broadcast.

Presetting Stations

You can preset 30 FM and 15 AM stations—using
either automatic presetting or manual presetting.
TUNER
In some cases, test frequencies have been already
memorized for the tuner since the factory examined the
tuner preset function before shipment. This is not a
malfunction.
BAND
TUNER
To preset stations automatically—Automatic
presetting
You need to preset stations separately for the FM and
AM bands.
On the remote control ONLY:
1
Press TUNER to select the
band.
The unit automatically turns on and
tunes in to the previously received
station—either FM or AM.
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold AUTO
PRESET for more than 2
seconds.
Local stations with strong signals are
searched for and stored in memory automatically.
When automatic presetting is over, the station
stored in preset number 1 is tuned in.
• Storing new stations erase the previously stored
one.
FM MODE 3
Repeat steps 1 and 2 to store stations
for the other band.
When you cannot automatically store stations
you want
Stations with weak signals cannot be detected with automatic
presetting. To store such stations, use manual presetting.
Continued
TUNER
AUTO AUTO
PRESET PRESET
12