STEP :: 08
CHANGE ID CODES
An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is
programmed in 1 of 2,000 ID Codes from the factory. The SportTrainer® SD-825E has the flexibility to
program two or more Remote Transmitters to the same ID Code, allowing them to control one Collar Receiver.
There are 64 programmable ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER'S ID CODE
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your Remote
Transmitter. This does not change the mode, so the current mode will still be active after the ID change
is complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and stay
on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then press
and release the Side Button. The green Indicator Light will flash rapidly confirming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit of the ID and
then press and release the Side Button. The green Indicator Light will flash rapidly confirming selection.
The 2nd digit is optional and, if not desired, wait until the green light turns off and refrain from pressing
the Side Button.
5. At the end of 15 seconds, or after the second press of the Side Button, the green Indicator Light will turn
off and the ID of the Remote Transmitter will be updated. At this point, the Remote Transmitter will be in the
same mode it was in prior to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter (see STEP 06).
TO RETURN THE REMOTE TRANSMITTER TO THE FACTORY ID
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your
Remote Transmitter. This does not change the mode, so the current mode will still be active after the
ID change is complete.
2. Do not press any buttons and wait until the green Transmitter Indicator Light turns off.
3. You will need to match the Collar Receiver to the Remote Transmitter (see STEP 06).
ACCESSORIES
To purchase additional accessories for your SportDOG® SportTrainer® SD-825E Remote Trainer, contact the
Customer Care Centre or visit our website at www.sportdog.com to locate a retailer near you.
14
sportdog.com