Peak Hold Measurements; Beeper Off - Amprobe 38XR-A Manual De Usuario

Button
< 1 second
< 1 second
< 1 second
> 2 seconds Exit MIN MAX AVG

Peak Hold Measurements

Note: The peak hold feature calibrates itself to meet the
specifications.
The function of the peak hold feature is to record and
store the positive and negative peak values that occur
while measuring ac current or ac voltage. To enable the
peak hold feature press the PEAK ± button for more
than 2 seconds. The display will show CAL to indicate the
calibration cycle is in process. After the CAL indication
clears, press the PEAK ± button again to display the
maximum (P+) value for the ac voltage or ac current
being measured. The display will toggle between the P+
and P- readings each time the PEAK ± button is pressed.
Press the PEAK ± button for more than 1 second to exit
the PEAK function.

Beeper Off

The beeper is an aural indicator to identify when the
DMM is performing a function, making a range change,
detecting a limit, and so on. To disable the beeper use
the following procedure:
1. Set the Function Switch to OFF.
2. Press and hold the HOLD button while turning the
Function Switch to the desired function. The no-beep
symbol N shows on the display.
Display
REC MAX
REC MIN
REC AVG
REC
Value Displayed
Maximum value after
feature activated
Minimum value after
feature activated
Average value after
feature is activated
Actual reading, min
max being recorded
Normal measurement,
actual reading
18