Hold Measurements; Backlight; Product Maintenance - Amprobe 34XR-A Manual De Uso

1. Set the Function Switch to OFF.
2. Press and hold the MIN MAX button while turning the Function Switch to
the desired function.
3. Continue to press the MIN MAX button until the display finishes this
initialization period and the reading settles.
4. Release the MIN MAX button. The Auto Power Off feature will remain
disabled until the meter is turned off and then on.

HOLD Measurements

The HOLD button causes the meter to capture and continuously display a
measurement reading. To use the HOLD feature make a measurement, and
then, after the reading has stabilized, momentarily press the HOLD button.
You can remove the test leads and the reading will remain on the display.
Pressing the HOLD button again releases the display.

Backlight

Pressing the button illuminates the display with a blue backlight. The
backlight will automatically turn off in about 60 seconds. Frequent use of the
backlight will decrease battery life.

PRODUCT MAINTENANCE

Cleaning
To clean the meter, use a soft cloth moistened with water. To avoid damage
to the plastic components do not use benzene, alcohol, acetone, ether, paint
thinner, lacquer thinner, ketone or other solvents to clean the meter.
Troubleshooting
If the meter appears to operate improperly, check the following items first.
1. Review the operating instructions to ensure the meter is being used
properly.
2. Inspect and test the continuity of the test leads.
3. Make sure the battery is in good condition. The low battery symbol
 appears when the battery falls below the level where accuracy is
guaranteed. Replace a low-battery immediately.
4. Check the condition of the fuses if the current ranges operate incorrectly.
7