Fronius MHP 280i G PM Manual De Instrucciones página 41

Contents
General
General
Functions of the torch trigger
Up/Down function
JobMaster function
Proper use
Safety
Warning notices on the device
Safety
Start-up
MTG d, MTW d - Fitting wearing parts to the torch body
Note regarding the inner liner with gas-cooled welding torches
Inserting a steel inner liner into the torch body
Inserting a plastic inner liner into the torch body
Fitting wearing parts inside the hosepack
Fitting the inner liner inside the hosepack
Attaching the torch body
Connecting the welding torch to the wirefeeder
Connecting the welding torch to the power source and the cooling unit
Threading the wire electrode
Setting the contact pressure
Changing the torch neck, rotating the torch neck
Changing the torch body
Rotating the torch body
Care, maintenance and disposal
General
Maintenance at every start-up
Every time the wirespool/basket-type spool is changed
Recognising faulty wearing parts
Changing the wirefeeding nozzle
Changing the infeed nozzle
Changing the feed rollers
Troubleshooting
Troubleshooting
Technical data
General
Gas-cooled welding torch - MHP 280i G PM
Water-cooled welding torch - MHP 320i W PM
Appendix
MHP 280i G PM, MHP 320i W PM
42
42
42
43
43
43
44
44
45
47
47
47
48
48
48
50
52
54
54
55
56
58
58
59
61
61
61
62
62
63
64
67
71
71
76
76
76
77
193
194
41