Connecting Wires To Terminals; Cable Routing; Factory Settings - Siemens SIMOTICS M-1PH818 Serie Instrucciones De Servicio

K3G280-RR03-M4
Siemens AG PD LD Nbg.

4.3.2 Connecting wires to terminals

WARNING
Live terminals and connections even with device
switched off
Electric shock
→ Wait five minutes after disconnecting the voltage at all poles
before opening the device.
; Remove the cap from the cable gland.
Only remove caps where cables are fed in.
; Route the wire(s) (not included in scope of delivery) into the terminal
box.
; First connect the "PE" (protective earth).
; Connect the wires to the corresponding terminals.
Use a screwdriver to do so.
When connecting, ensure that no wire ends fan out.
; Seal the terminal box.

4.3.3 Cable routing

Water must be prevented from reaching the cable gland along the cable.
NOTE
Damage caused by moisture penetration.
Moisture can penetrate into the terminal box if water is
constantly present at the cable glands.
→ To prevent the constant accumulation of water at the cable
glands, the cable should be routed in a U-shaped loop
wherever possible.# If this is not possible, a drip edge can
be produced by fitting a cable tie directly in front of the cable
gland for example.
When routing the cable, make sure that the cable glands are located at
the bottom. The cables must always be routed downward.

4.4 Factory settings

Factory settings made for the device by ebm-papst.
Mode parameter set 1 PWM control
Mode parameter set 2 PWM control
Fan/device address
01
Max. PWM / % 100
Min. PWM / % 5
Save set value to Yes
EEPROM
Set value requirement Analog (linear)
Direction of action Positive (heating)
parameter set 1
Direction of action Positive (heating)
parameter set 2
276
Item no. 55771-5-9970 · ENU · Change 94605 · Approved 2017-09-29 · Page 8 / 13
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions