Zanussi ZDT15003 Manual De Instrucciones página 23

1
A
3
Put the detergent or the
tablet in compartment (A).
B
If the programme has a
prewash phase, put a
small quantity of detergent
in compartment (B).
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on the
dishes.
We recommend that you use detergent tablets with long
programmes.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• All the programme indicators come on.
2
A
4
If the control panel shows other conditions, press and
hold function buttons (B) and (C) at the same time until
the appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press the button of the programme you want to set.
• The related programme indicator stays on.
• All the other programme indicators go off.
4. Close the appliance door. The programme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until the indi-
cator of the number of hours you want to set comes
on. You can set 3, 6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The countdown starts.
When the countdown is completed, the programme
starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you close
the door, the appliance continues from the point of inter-
ruption.
Cancelling the delay start
Press and hold function buttons (B) and (C) at the same
time until the delay indicator goes off and all the pro-
gramme indicators come on.
When you cancel a delay start, the appliance goes
back to setting mode. You have to set the pro-
gramme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at the same
time until all the programme indicators come on.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent acous-
tic signal operates.
1. Open the appliance door. The end indicator is on.
2. Press the on/off button to deactivate the appliance.
23