Foppapedretti Piuleggero Top4 Manual De Instrucciones página 14

• ENGLISH •
ASSEMBLY
UNFOLD THE STROLLER (fig.1)
Move button "a", as shown in the figure, while pressing button "b" at the same time.
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked.
FRONT WHEELS (fig.2)
Fitting the front wheels: Insert the end bushing into the slot situated in the center of the wheel
block. A click will indicate that it has been fitted correctly. Check that both the wheels have been
fastened correctly, if they are pulled downwards they should not be released.
Removing the front wheels: press the locking device "a", inner side, to release the wheel.
REAR WHEELS (fig.3)
Fitting the rear wheels: Insert the rear wheel group into the end of the tubes of the rear legs. The
wheel supports are correctly assembled when the metal pins "a" are locked in the corresponding
holes on the tubes of the chassis
Removing the rear wheels: Press the locking device "a", in the lower part of the leg and keeping it
pressed, remove the rear wheel group
FITTING THE CANOPY (fig.4)
Assembly: Insert the plastic clips "a" inside the respective guides located on both sides of the
stroller "b". You will hear a click when they are locked correctly in place.
Disassembly: pulling the lever "c" and lift to remove the canopy.
FITTING THE BUMPER BAR (fig.5)
Fitting the bumper bar: line the bumper bar up with the slots and press on both sides. A click
indicates that it has been fastened correctly.
Removing the bumper bar: press button "a" on both sides of the bumper bar and at the same time
pull to remove it.
Opening the bumper bar on just one side: press button "a" on one side of the bumper bar and pull
to open it like a gate.
SHOPPING BASKET
The basket is fitted on the lower part of the chassis.
The basket should be emptied before folding the pushchair.
USE
PARKING BRAKE (fig.6)
To apply the brake (6a): Press the brake lever, push the pushchair forward gently to ensure the
brake has been applied correctly.
To release the brake (6b): Lift the brake lever as shown.
ADJUSTING THE FOOTREST (fig.7)
Press buttons "A" and adjust the footrest in the required position.
ADJUSTING THE HOOD (fig.8)
Extend the hood according to requirements to protect baby from the sun.
14