Installation; Introduction; Max Room Temperature; Positioning - Angelo Po 3166220 Manual De Uso

- I N
- I N
- I N
After unpacking the appliance make sure it has not been damaged. (pict.21)
Make sure the technical wiring specifications comply with the ratings (i.e., V, kW, Hz,
no. phases and mains power Check the power supply type, adjustments,
performance and calibration of the device located before the appliance. Check and
record the coolant type inside the system and refer to the recorded data in any refill.
Please quote the product's serial number (shown on the rating plate) on any enquiry
to the Manufacturer. (pict.22)
A
A
List of rates shown on the rating plate:
1)
Model
2)
Manufacturer's name and address
3)
CE mark
4)
Year of make
5)
Serial number
6)
Power insulation class
7)
Power protection class
A)
Input voltage
B)
Electric current intensity
C)
Frequency
D)
Rated power
E)
Total lamp power
Air-condenser units should not operate if room temperature is over 38°C. Above 32°C amximum output is
not guaranteed.
The appliance must be installed and tested in full compliance with accident-prevention
regulations contained in national law and current guidelines. Installers are to comply
with any current local regulations.
An omnipolar switch is to be installed before the appliance, in compliance with the
current regulations applied in the country where the appliance is installed.(pict.24)
Do not place the refrigerated compartment near heat sources. (pict.25)
S T A L L A T
S T A L L A T
S T A L L A T

INSTALLATION

INTRODUCTION

1 2
B D
C N
B D
C
MAX ROOM TEMPERATURE (TAB.4)

POSITIONING

I O N M A N
I O N M A N
I O N M A N
3
6 4 5
R
P
Pict.22
F)
Fuse current
G)
Coolant type
H)
Coolant q.ty
L)
Temperature grade
M)
Max hydraulic supply pressure
N)
Room temperature
P)
Expanding fluid
R)
WEEE Symbol
S)
Water iniet temperature
T)
Water consumption
W)
Heating unit power
Z)
Least pressure
U A L -
U A L -
U A L -
7
E
F
Pict.24
Pict.25
Pict.21
13