Wiring; Please Use Certified Approved Materials - Angelo Po 3166220 Manual De Uso

- I N
- I N
- I N
Remove pvc protective film from all over the appliance. (pict.26)
Place the appliance onto the required working site.
(pict.27)
Avoid locations with exposure to direct sunlight.
Do not place the appliance in hot, poorly-ventilated rooms.
Leave a min. 100-mm clearance around the appliance on the sides where air
inlet and outlet are located. (pict.28)
For models, depth 700, it is possible to bring the rear of the appliance closer to the
wall.
Level the appliance by means of adjustable feet. (pict.29)
WARNING: If the appliance is not properly levelled the performance and condensate drain may be
hampered.
The connection to power supply may be carried out at the back of the appliance after
removing the protection grid. (pict.31)
IMPORTANT: 10kg models are equipped with a 2-mt single-phase cable without
plug.
All wiring cables are to comply with the ratings shown on the technical specifications.
Cables are to be connected to the equipotential terminal. (pict.34)
14
S T A L L A T
S T A L L A T
S T A L L A T

WIRING

PLEASE USE CERTIFIED APPROVED MATERIALS

I O N M A N U
I O N M A N U
I O N M A N
Pict.27
A L -
A L -
U A L -
Pict.26
Pict.28
Pict.29
Pict.31
Pict.34