Attaching The Abrasive; Securing Polishing Attachments; Auxiliary Handle - Festool ROTEX RO 150 FEQ Manual De Instrucciones

Soft: Universal use for coarse and fi ne sanding for
fl at and curved surfaces.
Super-soft: Fine sanding on formed parts, curves,
radii. Do not use on edges!
Installation
The FastFix system enables tool-free replacement
of the sanding pad (7.4):
– Set the switch (7.1) to the right, to the Rotex
rotary motion
– Press spindle stop (7.2),
– Turn the fi tted sanding pad from the spindle
(right-handed thread)
7.1
– Keep the spindle stop pressed and screw on the
new sanding pad (in doing so, make sure that the
rubber collar (7.3) is correctly fi tted!).
– Let go of the spindle stop.
7.2
the drive spindle is stationary. Do not switch on the
7.3
motor when the spindle stop is pressed in.
7.4

Attaching the abrasive

Stickfi x is a hook-and-loop fastening sys-
tem. Stickfi x sanding pads allow the use
of self-adhesive hook-and-loop abrasives
such as Stickfi x sandpapers and sanding
cloths.
Simply press the abrasive onto the sanding pad and
pull it off again after use.
aged Stickfi x hook-and-loop coating. Before use,
check that the coating has not been damaged by
improper use (such as over heating).

Securing polishing attachments

To prevent damage, use PoliStick polishing attach-
ments (sponges, felt, lambswool bonnets) only with
the special polishing pad fi tted on the tool instead of
a sanding pad. Like StickFix abrasives, the PoliStick
polishing attachments are simply pressed onto the
polishing pad and pulled off after use.
The auxiliary handle (Accessories, 8.1) can be
screwed onto either the right or left of the gear
head.
8
Actuate the spindle stop only when
Use only abrasives with an undam-

Auxiliary handle