Maintenance And Storage - Toro E24 Manual Del Operador

24. Stop motor before leaving the operator's
position—behind the handle. Remove key from
plug receptacle if mower will be unattended.
25. If mower must be lifted to be transported, stop
motor, stay behind the handle until all moving
parts stop and remove the key from the plug
receptacle.

Maintenance And Storage

1. Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or if assistance is desired, contact
your local Authorized TORO Service Dealer.
2. Before mower is cleaned, inspected, serviced, or
adjusted, stop motor and wait for all moving
parts to stop. Remove key from plug.
3. Do not charge lawn mower in rain or in wet
locations.
4. To prevent electric shock while charging, repair
or replace any damaged electrical cords
immediately.
Note: The extension cord is only needed to
recharge the battery. It is not used for
mowing with the mower.
5. Don't abuse extension cord while charging. Do
not yank cord to remove it from plug receptacle.
Keep cord away from heat, oil and sharp edges.
6. When replacing batteries, all batteries should be
replaced at the same time. Mixing fresh and
discharged batteries could increase internal cell
pressure and rupture the battery(ies).
7. When inserting the batteries into this product,
the proper polarity or direction must be
observed. Reverse insertion of batteries can
result in burned wires, sparks, leakage or
explosion of batteries.
8. Remove key before servicing, cleaning, or
removing material from the lawn mower.
9. Use only the following type and size
battery(ies): YUASA Maintenance-free
Rechargeable Battery YLM18-12 12V 17.2 Ah.
10. Do not dispose of the battery(ies) in a fire; the
cell may explode. Check with local codes for
special disposal instructions.
11. Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if
swallowed.
12. Exercise care in handling batteries in order not to
short the battery (contact both positive and
negative battery posts) with conducting materials
such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
13. To ensure the mower is in safe operating
condition, frequently check and keep all nuts,
bolts, and screws tight. Ensure blade bolt is
tightened to 35-40 ft–lb (48-54 N m
14. Always keep a sharp blade on your mower.
When servicing blade, refer to blade
maintenance section for correct installation and
servicing procedures. Use identical replacement
blades only.
15. To reduce fire hazard, keep motor free of
excessive grass, leaves, and accumulations of
dirt.
16. Check optional grass catcher bag frequently for
wear or deterioration. Replace with a new bag
when worn or damaged for your protection.
17. When not in use, remove key and store mower
indoors in a dry, locked-up place out of the reach
of children. Allow motor to cool before storing
in an enclosure.
18. At the time of manufacture, the mower
conformed to the safety standards in effect for
rotary mowers. To assure best performance and
continued safety certification of the mower, use
genuine TORO replacement parts and
accessories. Replacement parts and accessories
EN–4