Comet YA Serie Manual De Instrucciones página 25

WARNING
• These instructions and the guarantee certificate must always accompany the pump and be handed over to
the end user of the pump.
WARNING
• It is the responsibility of the
The specifications of the motor (electric motor or combustion engine) to be connected to the pump must
be suitable for the performance and the specifications of the pump (power, speed of rotation, flanges, etc.)
listed in the technical documents provided by the Manufacturer.
• The design of the machine with the pump must safeguard compliance with the safety standards required by
European Directives. This conformity is guaranteed by the
issued by the Manufacturer of the machine with the pump.
• The pump must be installed and operated horizontally.
• The pump must be fixed in a stable way by means of the feet that are supplied by the Producer.
• As this is a positive-displacement pump, it must always be fitted with a pressure control/limit valve.
WARNING
• Use of unsuitable optional accessories may endanger proper pump operation and may make it dangerous.
Only use the original accessories authorised by the Manufacturer.
• Read the documentation provided with the optional accessories for general information, safety notices and
instructions for installation and maintenance.
There are many optional accessories you can use in addition to the standard equipment supplied with the
pump:
• safety valve;
• pump shaft protection;
• control unit;
• suction filter (bottom basket);
• suction connector of various shapes and dimensions;
• pressure gauge;
• high-pressure delivery hoses;
• hose reel;
• spraying lances of various types.
Contact your dealer for further details.
CAUTION
• Pump applications must comply with the principals of good mechanics. The Manufacturer's Service
Department can provide any additional information for installers.
WARNING
• Protect the moving parts with suitable protections. Special care must be paid to the pulley applications and
to the power-take-off of the tractor.
• The pump must not work at a rotation speed that is higher than the one that can be read on the plate (10)
(see also what reported in paragraph "FEATURES AND TECHNICAL DATA").
• In case of through shaft, do not overcome the maximum available power values that shown in the table
below.
INSTALLATION
SKILLED TECHNICIAN
OPTIONAL ACCESSORIES
APPLICATIONS
to follow the instructions provided in this manual.
mark and by the Declaration of Conformity
EN
25