FALMEC QUASAR Manual De Instrucciones página 19

tive LED and switching-off of the LED associated with the velocity that was previously
selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the Key 3 will have no effect.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same Key.
4: 3rd Velocity
When the LED is switched-off and another velocity activated, pressing the Key (either
prolonged or not) implies the selection of the 3 rd velocity, the switching-on of the re-
spective LED and switching-off of the LED associated to the velocity that was previously
selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the Key 4 will have no effect.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same Key.
5: 4th Velocity
When the LED is switched-off and another velocity activated, pressing the Key (either
prolonged or not) implies the selection of the 4 th velocity, switching-on of the respective
LED and switching-off of the LED associated to the velocity that was previously selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the key 5 will have no effect.
The forth velocity must remain on for a maximum of 14 minutes, after which, one must
return to the third.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same key.
6: Light - Remote Binding
Light: Briefly pressing key T6 will turn the light on and off. The T6 key will light up if the light
is on.
Remote Binding (optional): With motor and light turned off, applying prolonged pressure
on the T6 key will activate remote binding mode. The T6 Key will flash for a maximum of 10
seconds. During flashing, at least one radio control key must be pressed. The function will
deactivate upon completion of the 10 seconds, or earlier if a compatible remote control is
detected.
Key pressure management:
Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates
during pressure.
Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function
activates upon its release.
Radio control (optional): Place the device far from sources of electromagnetic waves
which could interfere with the range hood's electronic functions
Maximum operating distance 4 metres. This distance may vary in defect based on elec-
tromagnetic interference of other devices.
Function of the
remote control
Light Key Pressing the Light key will switch the light on/off
Pressing the '-' Key will decrease motor speed. If 1° (1st) speed is in gear, pressing
' - ' Key
the '-' key will turn off the motor
DESCRIPTION
17