Safety Warnings - FALMEC QUASAR Manual De Instrucciones

Do not use abrasive products.
All the above operations must be performed after having disconnected the appliance from the
mains power supply.
M

SAFETY WARNINGS

The electrical system features an earth connection in compliance with international safety
standards; furthermore, it is compliant with the European standard for electromagnetic com-
patibility.
Do not connect the appliance to flues (from boilers, fireplaces, etc.). Make sure the mains volt-
age corresponds to the values on the rating plate located inside the range hood. The minimum
safety distance between the cooktop and the range hood must be at least 65 cm.
Never cook on "open" flames under the range hood.
Check deep-fryers during use: superheated oil may be flammable.
- Ensure there is adequate ventilation of the room when the rangehood is used at the same
time as appliances burning gas or other fuels.
- Do not flambe under the rangehood
- The exhaust air must not be discharged into a flue which is used for exhausting fumes from
appliances burning gas or other fuels.
- Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before
you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the appliance by un-
plugging it or using the main switch. The manufacturer disclaims all liability for any damage
that may be directly or indirectly caused to people, things and animals due to the failure to
follow all the instructions provided in this booklet and above all the warnings relating to the
installation, operation and maintenance of the appliance.
N
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or
transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and
operating characteristics.
O
MOUNTING INSTRUCTIONS, RANGE HOODS
Step 1
- Rest the support bar against the wall (A-Fig. O1) at a height from the cooktop determined by
the sum of the distance X+517,8 mm.
- Check the horizontal alignment with a spirit level and mark the 2 holes to be drilled at the
ends of the bar.
- Drill the holes, insert 2 x 8mm dia. screw anchors, and fasten the bar using the corresponding
screws.
Step 2
- Hook the range hood to the support bar (Fig. O2).
- Adjust the alignment of the range hood using the screws on the brack-ets (Fig. O2). The top
screw (B) adjust the distance from the wall, the bottom screw (C) adjust the height.
20