BABYTREND HC57XXXB Manual De Instrucciones página 4

ASSEMBLY
TO ASSEMBLE BOOSTER SEAT
• ONLY approved SNAP TECH products can be
TM
used on the frame.
4) • Slide Footrest posts into the front of the
Seat until it clicks into place (Fig. 4a).
• Connect the Seat and lock into place
(Fig. 4b). Pull up to make sure it's locked
firmly in place before use (Fig. 4c).
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO ATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
If your model has a Seat Pad and Seat Insert
on the Seat Back please skip ahead to Step 7.
Fig. 4a
5)
6)
Fig. 4b
TO REMOVE SEAT PAD
Reverse steps above.
Fig. 4c
• Thread non-buckle end of Harness Straps
called Harness Attachment Tabs through
the provided slots in the body insert, seat
fabric, seat back (Fig. 5a), and seat base
(Fig. 5b). When Harness Attachment Tabs
are through the provided slots, rotate the
Harness Attachment Tabs 90 degrees.
Make sure that the straps are firmly in
place.
• Loop the flap on the back of the pad
over the top of the Seat Back (Fig. 6a).
Connect the Seat Pad to the Seat Back
with the two Elastic Loops. These fit over
the Attachment Tabs located near the top
harness slots (Fig. 6b).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 5a
Fig. 5b
Fig. 6a
Fig. 6b
6