BABYTREND HC57XXXB Manual De Instrucciones página 5

ASSEMBLY
TO ATTACH TRAY
WARNING:
Always check
that the high chair is locked in
the open position before using.
WARNING:
The tray is not
designed to hold the child in the
chair. The child must be secured
by the safety harness at all times
while in the high chair.
7) • To attach the Tray, line up the Grooves
on the bottom of the Tray with the
armrests of the high chair. Squeeze the
front release handle and slide the Tray
onto the armrests (Fig. 7a). The Tray
has a 3-position adjustment. To adjust
the position, squeeze the front release
handle located underneath the Tray and
reposition the Tray to the desired position.
Release the Tray's handle. Make sure the
Tray is securely locked in its new position
before use.
ATTENTION:
Never leave the tray in a position where the
warning signs are visible (Fig. 7b).
TO ATTACH INSERT TRAY
8) • The dishwasher safe Tray Insert snaps
onto the High Chair Tray and is held in
place by tabs on the sides of the Tray.
When installing the Tray Insert make sure
that it snaps into place to prevent the child
from removing the Tray Insert. To remove
Insert unsnap tabs from the Tray (Fig. 8a).
7
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
TO USE SAFETY BELT
Groove
Fig. 7a
The Tray is not designed to hold the child in
the chair. Stay near and watch child during
use.
9)
Fig. 7b
Fig. 8a
• The Tray may be stored on the back legs
of the High Chair. Align the holes in the
rear of the tray with the small pegs on the
back legs (Fig. 8b).
WARNING:
It is
recommended that only children
capable of sitting upright
unassisted use the high chair in
the upright position.
WARNING:
Prevent
serious injury or death from falls
or sliding out. Always secure
child in the restraint system,
either in the reclining, semi-
reclining or upright position.
NEVER leave child unattended.
• The shoulder straps of the 5-point
harness have 2 attachment positions.
Select the position that places the
shoulder strap level with, or below, the
top of the child's shoulder (Fig. 9a).
• Carefully place the child in the seat and
position the safety harness around the
child's waist and over the shoulders.
Place the crotch strap between the
child's legs. Insert the male end of each
shoulder/waist belt into the buckle on the
crotch strap. Tighten the harness to be
snug around the child's waist and over the
child's shoulders (Fig. 9b).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 8b
Fig. 9a
Adjust for a snug fit
Fig. 9b
8