Connecting To The Electricity Supply - S&P TERMOTECH-MT Serie Instrucciones De Uso

2. SAFE LOCATION
• Only use the product in horizontal position with the heating surface facing downwards.
• The heating device must not be placed immediately under a power point and should not be
installed in a hollow space. The correct position is suspended, leaving at least 15 cm space
between the rear and the ceiling and 180 cm between the product and the floor.
• The front radiating surface of the panel should be free, unobstructed by objects that could
reduce its efficacy or damage it irreparably as well as causing a fire hazard. Leave at least
1-metre between the surface of the panel and possible objects directly underneath it. In
addition, it must be placed at least 50 cm from side walls.
• The product is manufactured with simple electrical insulation (Class I) and therefore requires
an earth connection.
• Always respect the minimum distances from walls, ceiling and floor as described in Fig. 1.
• Never install the product in contact with wooden or synthetic material surfaces.
• This product has grade IP54 protection against dirt and water.
3. INSTALLATION
• After carefully reading the safety warnings in the above paragraphs, secure the product us-
ing 4 metal chains of characteristics adequate to its weight.
• Inside the packaging there is an envelope with 4 eyehooks for installation (Fig. 2):
– Screw the 4 eyehooks into the nuts on the interior of the rear frame of the product (Do not
tighten them excessively).
– Slide the hooks to the best position, respecting the limitations expressed in the table in
Fig. 2.
– Tighten the hooks firmly until they are secured in the desired position.
• Identify the 4 points where the chains are to be secured, respecting the minimum distances
indicated in Fig. 1.
• Place the 4 chains in the chosen points using raw plugs or other anchoring systems ad-
equate for the weight of the product and the type of support you wish to use for anchoring.
• Hang the product from the chains using adequate securing elements.

4. CONNECTING TO THE ELECTRICITY SUPPLY

• Before carrying out any operation, remember to disconnect the power supply and make
sure that it cannot be reconnected accidentally.
• All products in this range must be installed and used by people with sufficient qualifications
and training.
• The appliance must be installed in compliance with national regulations as well as the speci-
fications detailed in this manual. Before installing the appliance, make sure the electricity
supply is suitable for the specifications of the appliance. Electrical connection to the mains
must also include the use of a multiswitch with a gap of at least 3 mm between contacts.
10