What To Do In Case Of Malfunctions - S&P CB-2005 Manual De Instalación. Instrucciones De Uso

Calefactor de baño
Ocultar thumbs Ver también para CB-2005:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
• Rapid heating:
Adjust the ambient thermostat to the required temperature and then turn
the timer knob to select the required operating time. The product rapidly heats
the room 1800W for the set time and then reduces power to 1000W to main-
tain the ambient temperature selected with the thermostat.
- When the heater is working under timer control at 1800W the thermostat doesn't
control the room temperature. In this condition, do not use the heater in small rooms
when they are occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided by a person responsible for their safety.
AUTOMATIC ANTI-FROST
- The CB-2005
Protection Device which switches the unit ON automatically when the temperature
is less than +50C. To activate this device when the heater is in use and turn the
Thermostat to position (*). Therefore when the temperature drops below +50C the
appliance will automatically switch ON keeping the room at this constant tempera-
ture. This device is very useful where low temperatures are common and where
pipeline water is easily frosted.
FILTER
- This product is fitted with a filter to protect the heating elements from dust and
dirt.
- The filter is removable and can be fitted both from the left and from the right,
figure 8.
- To keep the heater in perfect condition, clean the filter once every six months
REMEMBERING TO PUT IT BACK AGAIN AFTERWARDS.
TOWEL RAIL
- The towel rail can warm up to 2 towels at a time.
- Position the towels correctly on the rail, as shown in figure 9 and NOT as shown
in figure 10, to prevent overheating and malfunctions.

WHAT TO DO IN CASE OF MALFUNCTIONS

- In the event of overheating, the safety device on the appliance automatically
disabled the heating elements and motor. As a result, the heater stops working,
even though the indicator LED stays on.
- In this case:
- Turn off the fan heater and allow it to cool down for about 15/20 minutes.
- Make sure the dust filter is not totally obstructed and clean if necessary.
- Remember to put it back again afterwards.
wall mounted heater incorporates as standard an Anti-Frost
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cb-2005 ts

Tabla de contenido