Halyard ON-Q Instrucciones De Uso página 7

External pressure
• External pressure such as squeezing or laying on the
pump increases flow rate.
Indications for Use
• The ON-Q* Pump is intended to provide continuous
delivery of medication (such as local anesthetics) to or
around surgical wound sites and/or close proximity to
nerves for preoperative, perioperative and postoperative
regional anesthesia and/or pain management. Routes
of administration include: intraoperative site, perineural,
percutaneous and epidural.
• ON-Q* Pump is indicated to significantly decrease pain
and narcotic use when used to deliver local anesthetics
to or around surgical wound sites, or close proximity
to nerves, when compared to narcotic only pain
management.
Contraindications
• ON-Q* Pump is not intended for blood, blood products,
lipids, fat emulsions, or Total Parenteral Nutrition (TPN).
• ON-Q* Pump is not intended for intravascular delivery.
Description of Device (Figure 1)
The ON-Q* Pump with SELECT-A-FLOW* device incorporates
a controller that allows the user to adjust the infusion rate.
1
Fill Port
2
ON-Q* Pump
3
Clamp
4 Air-Eliminating Filter
5
SELECT-A-FLOW* Variable Rate Controller
6
Flow Rate Dial
7
Rate-Changing Dial Key
8
Flow Rate Window
9
Lockable Cover
Figure 1
4
9
1
2
3
7
6
8
5
Medication Label (Figure 2)
Medication Label Symbol Definitions:
1
Patient Name
2
Date
3
Time
4
Medication
5
Dosage
Figure 2
1
2
3
SELECT-A-FLOW* Device Description
SELECT-A-FLOW* device is a flow controller that allows the
user to adjust the infusion rate by turning the rate-changing
dial key on the device. The flow rate is within a predetermined
range and is designated on each device.
To discourage tampering: (Figure 3)
1. Remove the dial key from the device by pulling it straight
out. Put the dial key in a safe place for later use, e.g.,
attached to a key ring.
2. Close the cover over the SELECT-A-FLOW* Variable Rate
Controller.
3. For increased tamper resistance, the cover may be locked
to the SELECT-A-FLOW* Variable Rate Controller using the
tie-wrap.
Figure 3
Rate-Changing Dial Key
Plastic Cover
Note: If desired, the cover may also be removed from the
SELECT-A-FLOW* device by fully opening the cover and then
pulling straight up on the plastic feet at the bottom of the cover.
4
5
Flow Rate Window
Tie Wrap
5