Mounting The Hood Body - Faber CITY EG6 W/X A80 Manual De Instrucciones

Mounting the hood body

• Adjust the two screws Vr, on brackets 11a, to a min-
imum.
• Hook the hood canopy onto the two brackets 11a.
• Open the Grid by acting on the special handles
• From inside the hood canopy, adjust the screws Vr to
set the Hood Canopy level.
• Tighten the safety screws 12a.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150
or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert
the reducer flange 9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove possible charcoal filters.
EN
Connections
11a
Vr
12a
ø 120
ø 150
9
1
10