Troubleshooting Chart - EMAK efco LR 38P Manual De Instrucciones

I
WARNING: always stop the machine and disconnect the safety connector before
carrying out the corrective checks recommended in the table below, except when they
require the machine to be in operation.
GB
When you have checked all the possible causes listed and you are still experiencing the problem,
see your Servicing Dealer. If you are experiencing a problem that is not listed in this chart, see your
Servicing Dealer for service.
F
PROBLEM
Engine will not start or will
run only a few seconds after
D
starting.
E
SK
P
Engine starts and runs, but
GR
blade is not rotating
W A R N I N G : N e v e r
touch the blade while
TR
the engine is running.
WARNING! Also read the battery and battery charger instruction and maintenance
manual!
CZ
RUS
UK
PL
24

13. TROUBLESHOOTING CHART

POSSIBLE CAUSE
1. Battery drained or fitted
incorrectly
2. Power cable damaged.
3. Motor protector triggered
due to engine overheating.
4. Connector or safety plug
not inserted
5. Starting lever microswitch
damaged
6. Damaged battery
SOLUTION
1. Charge the battery or fi t it
correctly
2. Have the cable replaced by an
Authorised Service Centre.
3. Wait several minutes before
restarting the machine.
4. Check and/or insert
5. Contact an Authorized Service
Centre
6. Contact an Authorized Service
Centre
Switch off the motor immediately
and contact an Authorised Service
Centre.