Faber ARKEA Manual De Instrucciones página 12

• Tighten the power supply cable and fix it to the
bracket on the ceiling-mounted plate, using the
tongue already mounted and 2 screws.
• Slot the rubber cable raceway already threaded
onto the power cable into the slot to prevent
future damage.
• Connect the Hood to the Mains Power Supply,
inserting a bipolar switch with a contact
aperture of at least 3 mm.
• Remove the Grease filters (see paragraph
"Maintenance") and make sure that the Power
cable connector has been properly inserted into
the Suction fan socket.
• At this point it is possible to remove the tie
fixing the power supply cable to the hood
canopy.
• Screw the cover back onto the plate
using the screws removed as
described above.
• Open the lighting unit by pulling on the notch provided.
• Remove the grease filter.
• Make sure that the Activated charcoal odour filter has been fitted.
EN
FIXING THE POWER SUPPLY CABLE
FITTING THE PLATE COVER
AIR OUTLET – RECIRCULATION VERSION
1 12