Foppapedretti Express Manual De Instrucciones página 21

• ENGLISH •
the diagonal part passes over the armrest of the car seat (12).
Fasten the passenger seat belt, making sure it is not twisted (12).
Push the car seat firmly up against the passenger seat and tighten the seat belt
as much as possible, pulling the lap part and the diagonal part in the direction of
the winder (13).
Release the shoulder strap buckle by pressing the red button located in the centre
of the buckle.
Place your child in the car seat.
The liftable armrests make access to the car seat easier and facilitate installation.
Bring together the ends of the shoulder straps and insert them into the buckle,
until you hear a "click" (14).
Pull the adjustment belt of one shoulder strap until it is sufficiently tight against
your child (15). Repeat this process with the adjustment belt of the second strap.
WARNING: the straps must be adjusted so that they fit snugly to the child's build,
without being too tight.
WARNING: before travelling, always check that the armrests are lowered. It is
essential that the shoulder straps are properly adjusted to protect your child as
much as possible. The gap between the shoulder straps and the child must not
be greater than the thickness of your finger.
Gr. 2-3, from 15 to 36 kg (from around 3 to 12 years of age approximately)
Before installing the car seat in the car, check that the car seat shoulder straps
have been removed.
To remove the shoulder straps: if necessary, press the red button on the buckle
to release the shoulder straps.
Remove the shoulder straps by following steps (3) and (4) for each upper end of
the harness.
To store the shoulder straps in the car seat shell: hold one free end of the
shoulder strap and pass it on the back of the backrest through the side openings
of the cover and shell (16). Insert the metal ring, the harness stop device, into the
slot on the back of the car seat's backrest towards the inner side and lock the ring
of the locking device (17).
The metal stop device must be placed between the shell and the cover of the
car seat.
Repeat this for the second end of the harness.
21