CASUALPLAY Vintage 2 Instrucciones De Uso página 13

INSTRUcTIONS FOR USE
Unfolding (see illustrations 1 - 2)
• Release the locking device situated on the crossbar on the left of the chassis (fig. 1).
• Proceed to unfold the pushchair pulling the handlebar firmly upwards (fig. 2).
IMPORTANT: The VINTAGE 2, comes without the rear wheels fitted, before unfolding the
pushchair for the first time proceed to fit them in the following way: Fitting the rear wheels
(see illustration 3).
• Fit the rear wheels (fig. 3) by pressing the central button and inserting the axle into the hole of the
rear wheel bearer.
• Release the button and check that the wheel is securely fastened and turns freely.
Folding (see illustrations 4 - 6)
NOTE: Before folding the pushchair, position the vintage 2 seat facing forwards.
• Simultaneously press the folding button and the safety lever upwards (fig. 5) and push the
handlebar forwards (fig. 6).
• Completely fold the chassis and check that the locking device (coloured red) has secured the
chassis to prevent it from accidentally opening.
locking the front wheels (see illustration 7)
• The front wheels can be used in a fixed or free position. To set them to the free position the small
levers on both sides should be placed in the upper position. For the fixed position, move these
levers downwards and when the pushchair starts moving the wheels will be automatically fixed
(fig. 7).
Adjusting the footrest (see illustration 8)
• To extend the length of the footrest pull the flange on the front of it outwards (fig. 8).
Adjusting the backrest (see illustrations 9-12)
• The backrest of the VINTAGE 2 has 3 reclining positions. Pull the reclining system lever upwards
(fig. 9), and move the backrest to the required position, (fig. 10 - 11 - 12) once the position has
been selected, release the lever.
Hood and rain cover (see illustrations 13 - 15)
• Fit the hood by inserting the guides on both ends into the slots situated on the sides of the pushchair
(fig. 13). It will click into place when correctly fastened. To remove the hood, press the front tab of
the guide upwards and pull forwards.
• The hood consists of two parts that can be removed using the zip in the middle (fig.14 - 15).
• The rain cover is fitted onto the pushchair with the hood extended, then fasten the side Velcro
strips to fasten it (fig. 16).
Basket (see illustrations 17 - 18)
• The basket on the lower part of the pushchair is fastened using the buckles on the front part
(fig.17) and the clasps on the rear part, this means it can be removed easily (fig. 18).
• The maximum weight that can be carried in the basket is 5 kg.
• It is advisable to empty the basket before folding the pushchair up.
11