Humidifying Tray - Sharp KC-850U Manual De Operación

Purificador de aire con función de humidificación
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HUMIDIFYING TRAY

1 month
Care Cycle
1
Remove the Water Tank and Humidifying Tray.
Unlatch the Water
Tank first, then re-
move the tray. Use
both hands when
pulling out the
Humidifying Tray to
avoid spilling water.
2
Remove the Water Tank and Humidifying
filter from the Humidifying Tray. Drain ac-
cumulated water by tilting the Humidify-
ing Tray slowly.
Humidifying filter
3
Rinse the inside of the Humidifying
Tray with lukewarm water to remove
impurities.
• Do not remove the
Styrofoam float .
• Clean difficult-to-
reach parts with a
cotton-tipped swab
or tooth brush.
4
Replace the Humidifying filter and re-
place the Humidifying Tray in the unit.
The Humidifying filter will not
fit if placed in backwards. Be
sure there is no gap between
the Humidifying tray and the
unit when the Humidifying Tray
is replaced in the unit. The unit
may not operate properly if the
Humidifying Tray is not prop-
erly replaced in the unit.
If the Styrofoam float comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.
Frequency of maintenance cycle will depend on the hardness
of the water. Avoid spilling water when removing or cleaning
the tray.
Tank Handle
Water Tank
Do not hold
this part.
Humidifying
Tray
Float
Color:Gray
Insert the tab of the
float into the hole.
E-17
When Water Deposits are Difficult to Remove
1
Fill Humidifying Tray halfway
with lukewarm water, add a
small amount of mild kitchen
detergent, and leave to soak
for about 30 minutes.
Dilute detergent according to
instructions on the container.
Clean difficult-to-reach parts
with a cotton swab or tooth
brush.
2
Rinse the Humidifying
Tray with lukewarm water.
• Rinse until all detergent residue
is removed.
• Inadequate rinsing may
cause the detergent
odor or changes
in the shape/ color
of the main unit.
CAUTION
• Use only mild kitchen detergents to
clean the Humidifying Tray. Use of
non-designated chemicals or deter-
gents can cause deformation, tarnish-
ing, cracking (water leakage).
Insert the float below
this tab.
I n s e r t t h e t a b o n
the other side of the
float into the hole.

Publicidad

Tabla de contenido
loading

Tabla de contenido