Maintenance - Thermador MBEB Manual Del Operador Y Instrucciones De Operación

Maintenance

Before Requesting Service
The oven causes interference with
my TV.
Steam accumulates on the oven
door and warm air comes from
the oven vents.
P o r b e l m
Oven will not turn on.
Problem
Oven will not start cooking.
Error message "Exxxx"
The Glass Tray wobbles.
When the oven is operating,
there is noise coming from the
Glass Tray.
The word "LOCK" appears in
the Display Window.
These things are normal
Some radio and TV interference might occur when you cook with the microwave
D
oven. This interference is similar to the interference caused by small appliances
such as mixers, vacuums, blow dryers, etc. It does not indicate a problem with
your oven.
During cooking, steam and warm air are given off from the food. Most of the
D
steam and warm air are removed from the oven by the air which circulates in the
oven cavity. However, some steam will condense on cooler surfaces such as the
oven door. This is normal. After use, the oven should be wiped dry.
P o s s b i e l c a u s e
The oven is not plugged in securely.
Reset the household circuit breaker or
replace any blown fuses.
There is a problem with the outlet.
The door is not closed completely.
Start Pad was not pressed after
programming.
Another program is already entered into
the oven.
The program is not correct.
Pause/Stop Pad has been pressed
accidentally.
The Glass Tray is not positioned
properly on the Roller Ring or there is
food under the Roller Ring.
The Roller Ring and oven bottom are
dirty.
The CHILD LOCK was activated.
R e m e d y
Remove plug from outlet, wait
10 seconds and reinsert.
Reset circuit breaker or replace furse.
Plug another appliance into the outlet to
check if it is working,.
Close the oven door securely.
Press Start Pad.
Press Pause/Stop Pad to concel the
previous program and enter new
program.
Program again according to the
Operating Instructions.
Program oven again.
If an error message is displayed,
please contact the aftersales service
and provide the fault code.
Take out Glass Tray and Roller Ring.
Wipe with a damp cloth and reset Roller
Ring and Glass Tray properly.
Clean these parts according to Care and
Cleaning of your Microwave oven.
See section Function Feastures.
37