Fermax kits EVOLUTION AVISA Manual Usuario página 22

Kits EVOLUTION
Kits EVOLUTION
Alarms
Detecta4 and Avisa Kits have 4 independent alarm zones (Zone1...Zone4) that can be controlled from the
monitor (arm and disarm alarm zones, check status of alarm zones...).
Each alarm zone is formed by at least one detection sensor (the kits include 4 intrusion sensors) that set off
an alarm if any intruders are detected.
Zone1 is the entry-exit zone. It has a delay (30 seconds by default. This time is configurable, please consult
your installer) that allows the user a minimum time to arm or disarm the alarm zones when entering or
leaving the home, without setting off any alarms.
Detecta4 and Avisa systems admit and must be extended with any type of sensor detectors: Intrusion,
Water, Gas, Smoke.... and you can install as many detectors per zone as you wish (please consult your
installer for extensions).
When the system detects something, it generates alarm signals: acoustic alerts, device activation... (for
further details, see the «Setting off Alarms» section).
Kit connection to an Alarm Reception Centres
Detecta4 and Avisa Kits are prepared for connection to an Alarms Reception Centre, so enhancing the
security of your home.
To connect to an Alarm Reception Centre, please consult your installer.
Pag 8