Fermax kits EVOLUTION AVISA Manual Usuario página 25

Kits EVOLUTION
Kits EVOLUTION
Check Alarm Zone Status
It is possible to check the alarms system status from the Detecta4 monitor.
The possible states the alarms system may present is as follows:
- General system arming.
- Alarm set off.
- Alarms enabled.
Check system status:
- General System Arming: If the system has been armed. Slow blinking of
the ''Red LED'' on the monitor.
- Alarm Set Off: If an alarm has gone off. Fast blinking of the ''Red LED''
on the monitor (in addition to the acoustic alerts and to the sending of the
corresponding messages).
- Alarm Zones Enabled:
To be able to activate arming of the alarms Zones, the system must be
«enabled».
The alarms system of Avisa and Detecta4 Kits comes enabled from the factory. There is no need
to enable the system previously. All you need to do is arm or disarm the system to activate the
alarm Zones.
From the Detecta4 monitor, you can check on the current state of the alarms system, simply by keying,
on the telephone keypad, the code corresponding to the zone you want to check, followed by the ''*'' key
(N*, where N is the zone number).
The monitor informs you whether the system is enabled or disabled by means of the red LED and a
series of acoustic alerts that tell you which zone has been checked.
Once the code has been keyed in order to check the corresponding zone, the correct code
confirmation tone is heard (
zone number entered, and the zone status is signalled by the red LED:
ACTION
4 Zones Status
Zone 1 Status
Zone 2 Status
Zone 3 Status
Zone 4 Status
If the Zone is configured in «24 Hour Mode» the three LEDs (green, yellow and red) light up.
) followed by a number of beeps (
KEY SEQUENCE
0*
1*
2*
3*
4*
ACOUSTIC
INFORMATION
+
+
+
+
1
1 2 3
F
4 5 6
7 8 9
* 0 #
A B C
), corresponding to the
ZONE STATUS
Enabled Disabled
Lit
2.5 sec. LED ROJO
Lit
2.5 sec.
Lit
2.5 sec.
Lit
2.5 sec.
Lit
2.5 sec.
F E R M A X
RED LED
Off
Off
Off
Off
Off
Pag 11