Monitor Configuration; Call Tone Volume; Multifunction Button - Fermax kits EVOLUTION AVISA Manual Usuario

Kits EVOLUTION
Kits EVOLUTION

MONITOR CONFIGURATION

The monitor lets you configure and adjust the following parameters and options:
- Adjust Call Volume.

- Multifunction Button.

- Tune Selection.
- Change Master Code.
To configure the different monitor options and adjustments, you must use the phone keypad to enter the
programming code, followed by a sequence of codes, depending on the adjustment or configuration to be
made.
Programming entry code: Master Code + AB
Below is a detailed description of each of the possible adjustments.

Call Tone Volume.

VOLUME LEVEL
LOW
HIGH
Once the volume level is selected, you can hear the call tone by pressing the telephone hang up button.
Multifunction Button.
The function of this button can be selected from among 3 possible functions:
* Activation of an auxiliary device (if installed, please consult your installer).
* Panic call: Sends a panic alert (emergency call) to a panic guard unit (if
there is one).
* Connection to Alarms Reception Centre.
MULTIFUNCTION BUTTON
FUNCTION
AUXILIARY DEVICE ACTIVATION
PANIC CALL
ALARMS RECEPTION CENTRE
Pag 12
KEY SEQUENCE
Master Coder + AB + 6+0
Master Code + AB + 6+1
KEY SEQUENCE
Master Code + AB + 7+0
Master Code + AB + 7+1
Master Code + AB + 7+2
EXAMPLE
1234AB60
1234AB61
HANG UP
BUTTON
1
1 2 3
F
4 5 6
7 8 9
0 #
*
A B C
EXAMPLE
1234AB70
1234AB71
1234AB72
F E R M A X
RED LED