Safety Harness - CASUALPLAY Sono Instrucciones De Uso

• To open the buckle, press the red button.

SAFETY HARNESS

• Fasten the buckle and tighten the chest straps by pulling the end of the tightening strap (fig.06),
until achieving the required fit, taking care to always leave some space.
IMPORTANT: Make sure that the harness straps are not twisted.
• To loosen the harness, press the tightening button and pull the chest straps with the other hand
(fig.07).
ADJUSTING THE HEIGHT OF THE HARNESS
• Find the metal plate on the lower part of the backrest of the Sono (fig.08) and release the shoulder
straps of the harness. Take the shoulder straps out of the vents in the seat and the mattress pad.
• Insert the shoulder straps through the required vents (fig.09) and insert them back into the metal
fork making sure that they are correctly positioned. Check that the straps are not twisted.
IMPORTANT: Where the straps come out of the backrest, they should be at the height of the
child's shoulders and both at the same level (fig.10).
INSTALLING THE SONO IN THE CAR
• Set the handle to position A - fig.02.
• Fasten the buckle of the car seat belt and pass the abdominal strap through the two lower belt
guides (fig.11).
• Next, pass the chest strap through the upper belt guide on the same side as the retractor (fig.12).
WARNING: Adjust the tightening of the seat belt every time you change the position of the
backrest.
• Lastly, tighten the seat belt by pulling the chest strap (fig.13).
REMOVING THE UPHOLSTERY
• Remove the foot cover.
Remove the hood.
•
• Unfasten the harness buckle.
• Remove the chest protector pads and the reduction cushion. Pass the harness straps through the
vents in the upholstery.
• Take the upholstery off, starting with the front part.
UNISYSTEM
This exclusive fastening system means that the Sono can be used on the following pushchairs:
Avant, Livi, Kudu, Kudu 4, S4, S-Twinner.
For all of them, the installation procedure is the following:
• Put the parking brake on.
• Place the Sono on the pushchair, facing backwards.
• Line the Sono Unisystem fasteners up with the slots (fig.14).
• Press downwards until it clicks into place and a green signal appears in each of the windows on
the sides of the fasteners (fig.15).
• To remove it, press and then release the red button on both fasteners (window displays red signal)
and pull upwards to release it from the chassis of the pushchair (fig.16).
español
11