Safety Harness - CASUALPLAY Baby Zero Plus Manual De Instrucciones

• Insert the shoulder straps through the appropriate slots (fig.7) and insert them back into
the metal plate, making sure that they are correctly positioned. Check that the straps
are not twisted.
IMPORTANT: where the straps come out of the backrest, they should be at the
height of the child's shoulders and both at the same level (fig.8).
IMPORTANT: Make sure that the harness straps are not twisted.
Opening and closing the harness buckle
• Bring the two parts of the harness chest straps together and insert them into the female
part of the buckle. Then press them both until they click fastened (fig.9).
• To undo the buckle, press the red button.

Safety harness

• Loosen the shoulder straps by pressing the button that slackens them while using the
other hand to pull the shoulder straps upwards (fig.10).
• Unfasten the harness by pressing the red button and place the shoulder straps at the
sides of the seat.
• Settle the child in the Baby Zero Plus and put the harness on. Make sure that the straps
are not twisted.
• Fasten the buckle and tighten the chest straps by pulling the end of the tightening strap
(fig.11), until obtaining the required fit, taking care to always leave a little slack.
IMPORTANT: Make sure that the harness straps are not twisted.
• To loosen the harness, press the button on the tightening device and pull the chest
straps with the other hand (fig.12).
NOTE: Check that the padded parts and the buckle are correctly in place. They
are two parts that are very important for safety and must be used always.
How to take the child out of the Baby Zero Plus
• To take the child out of the Baby Zero Plus, loosen the shoulder straps by pressing the
harness adjuster while pulling the two shoulder straps with the other hand (fig.12).
• Unfasten the harness by pressing the red button and place the shoulder straps at the
sides of the seat.
21 21