KERN HCB Serie Manual De Instrucciones página 4

Operating Instructions Electronic Hanging Balance
KERN HCB
Read-out
Weighing Range 20 kg
To fit or exchange the battery
Push off the battery cover on the back of the balance in the direction of the arrow. Insert 3 AAA
batteries. Replace the battery cover. When the battery power is used the display will show "LO".
Press the OFF key and change the batteries at once. To preserve battery life the balance switches
off automatically after 4 minutes if no weighing has taken place.
Weighing
• The balance is switched on by pressing the
"ON/OFF" key.
• The balance display shows "0.00".
• Hook the object being weighed.
• The steady reading is the weight of the object.
• If the weighing object is heavier than the
weighing range the display indicates "E"
(=Overload).
• The balance is switched off by pressing the
"ON/OFF" key once.
Important using informations
NO
- Don't use with pressure
4
20K50 50K100
50 g 100 g
50 kg
100K200
200 g
100 kg
Taring
• Switch the balance on with "ON/OFF" key and
wait for "0" to appear in the display. Hang the
tare load and press the "TARE" key again.
• The balance display becomes "0.00". The
weight of the tare load has however been
memorised internally. The item to be weighed
can now be placed in the tare container and the
weight can be read off..
Data HOLD
• When the HOLD key is pressed, the display
value (even when the weight values vary)
shown on the display will be held 5 seconds.
NO
- Don't twist
200K500
500 g
200 kg
O.K.
- Just using with tension
HCB-BA-defsi-0210
E