GB
The sawblade rides outside the cutting line or does not ride correctly:
The sawblade does not ride in the middle of the wheel.
Change the tilt of the upper wheel of the saw.
If the sawblade is distorted, replace it.
The blade is broken:
The sawblade tension is incorrect – adjust it.
Too heavy a load – reduce the pressure on the sawblade.
The blade is distorted: you will get very thin workpieces if the sawblade is too thin and very thick workpieces if the sawblade
is too wide.
The blade is buckled:
Too heavy a load – avoid lateral pressure on the sawblade.
The saw vibrates:
The saw is not properly secured; secure the saw correctly to an appropriate floor.
The table is unstable; adjust and secure the table.
The motor mount is unstable; check the state of the retaining screws and tighten them down if necessary.
The sawdust extraction outlet is blocked:
The extraction device has not been connected or the suction capacity is insufficient. Connect the suction device or increase
the suction capacity (air speed > 20 m/sec in the sawdust extraction outlet).
14.
ACCESSORIES
1. Stand (Fig. 34)
The stand provides an optimum working height of 1,090 mm.
2. Trolley (Fig. 35)
The trolley is ideal for transport purposes. The saw can only be operated on a stand.
15.
TECHNICAL DATA
•
Model RBS 5518
•
Voltage: 230 V (1~50 Hz)
•
Power: 780 Watt
•
Current rating 3.5 A
•
Fuse: A 10 (delayed action or automatic - K)
•
Type of protection IP 54
•
Nominal idling speed:1400 + / - 10% min- 1
•
Cutting speed:
•
Blade speed (fast): 800 + / - 10% m/min
•
Blade speed (slow): 370 + / - 10% m/min
•
Sawblade size: 2,240 mm
•
Throat capacity: 305 mm
•
Maximum sawblade width: 15 mm
•
Maximum sawblade thickness: 0.5 mm
•
Maximum height of cut: 180 mm
•
Outside dimensions: 590 x 505 x 1,265 mm
•
Weight excluding accessories: 67 kg
•
Sound emission levels when idling
A- Sound pressure level LPA: 67 dB(A)
A- Sound power level LPA: 78 dB(A)
•
Sound emission levels when sawing:
A- Sound pressure level LPA: 85 dB(A)
A- Sound power level LPA: 91 dB(A)
26