Symbols And Safety Warnings; Main Components; Assembly (Explanations On How To Remove The Packaging And Assemble Detached Parts) - EMAK Oleo-Mac BV 901 Manual De Instrucciones

Use protections against noises; for example
noise reduction ear guards or earplugs.
The use of protections for the ear requests
much more attention and caution, because the
perception of danger audio signals (screamings,
alarms, etc.) is limited.
Wear gloves that permit the maximum
absorption of vibrations.
2. SYMBOLS AND SAFETY WARNINGS (Fig.19)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. WARNING - The blower may throw objects
at high velocity that can ricochet and hit
the operator. This may cause serious eye
damage.
Type of machine: BLOWER.
4.
5. Guaranteed sound power level.
6. CE conformity marking.
7. Serial number.
8. Year of manufacture.
3. MAIN COMPONENTS (Fig.1)
1. Frame
2. Air filter
3. Spark plug
4. Starter handle
5. Engine cowling
6. Fuel tank
7. Harness
8. Cushion
9. Elbow tube
10. Flexible tube
11. Control handle
12. Swivel blower tube
13. Blower tube screw collar
14. Telescopic blower tube
15. Nozzle reducer
16. Round terminal nozzle
17. Rectangular terminal nozzle
18. Vibration mounts
19. Mixture preparation bottle
20. Combination wench
21. M5x65 screws (no.2)
22. M6 nuts (no.2)
23. 120 mm dia. hose clamps (no.2)
4. ASSEMBLY
Assembling the tubes/handgrip
WARNING – When fitting the tube and
nozzle, the engine must be off and the switch
in the STOP position.
To assemble the blower read the following
instructions.
Machine components
Refer to Fig.3:
1. Insert the elbow tube into the fan casing.
2. Secure the elbow with the two screws and
two nuts supplied using the hex wrench
incorporated in the spark plug wrench
(supplied).
Refer to Fig.2:
1. Fit one of the two clips (24, Fig.1) to the
completely cylindrical end of the flexible
tube (A). Fit the shorter end of the flexible
tube (A) to the elbow (9, Fig.1) and, using
the wrench provided, tighten the screw to
secure the clip fitted previously.
2. Attach the end of the blower tube (B) with
the expansion slots to the free end of the
flexible tube (A) and tighten with the other
clip (24, Fig.1), locating it in the groove
presented by the slotted section. The swivel
movement of the tube (B) is adjusted by
tightening the clip to a greater or lesser
degree.
3. Fit the handle (C) to the blower tube (B),
having first completely loosened the screw
located under the locking lever (Fig.5) using
the hex wrench provided.
4. Looking at Fig.4: With the locking lever
lowered (locked), tighten the screw
sufficiently to secure the handle to the
blower tube, but no harder. Do not tighten
GB
21