Symbols And Safety Warnings; Main Components; Assembly (Explanations On How To Remove The Packaging And Assemble Detached Parts) - EMAK Oleo-Mac BV 900 Manual De Instrucciones

much more attention and caution, because the
perception of danger audio signals (screamings,
alarms, etc.) is limited.
Wear gloves that permit the maximum
absorption of vibrations.
2. SYMBOLS AND SAFETY WARNINGS (Fig.15)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. WARNING - The blower may throw objects
at high velocity that can ricochet and hit
the operator. This may cause serious eye
damage.
4. Type of machine: BLOWER.
5. Guaranteed sound power level.
6. CE conformity marking.
7. Serial number.
8. Year of manufacture.
3. MAIN COMPONENTS (Fig.1)
1. Frame
2. Air filter
3. Spark plug
4. Starter handle
5. Engine cowling
6. Fuel tank
7. Harness
8. Cushion
9. Elbow tube
10. Flexible tube
11. Control handle
12. 13. 14. Blower tubes
15. Round terminal nozzle
16. Rectangular terminal nozzle
17. Vibration mounts
18. Mixture preparation bottle
19. Combination wench
20. M5x65 screws (no.2)
21. M6 nuts (no.2)
22. 90 mm dia. hose clamps (no.2)
23. Antistatic cable
4. ASSEMBLY
Assembling the tubes/handgrip
WARNING – When fitting the tube and
nozzle, the engine must be off and the switch
in the STOP position.
To assemble the blower read the following
instructions.
Machine components
Refer to Fig.3:
1. Insert the elbow tube into the fan casing.
2. Secure the elbow with the two screws and
two nuts supplied using the hex wrench
incorporated in the spark plug wrench
(supplied).
Refer to Fig.2:
1. Fit the hose clamps on the two ends of the
flexible tube (10, Fig.1), without tightening
them.
2. Fit the flexible tube onto the elbow tube (9,
Fig.1) and onto the blower tube (12, Fig.1)
taking care to ensure that the cone (A, Fig.2)
is positioned towards the blower tube; now
tighten the two hose clamps using the
supplied wrench.
3. Fit the control handle (11, Fig.1) on the blower
tube (12, Fig.1) after fully undoing the screw
located under the locking lever (Fig.5) using
the supplied hex wrench.
Refer to Fig.4:
1. With the locking lever in its lowered
position (locked), tighten the screw
sufficiently to secure the control handle to
the blower tube but without tightening it fully.
Do not tighten the screw with the lever in
the open position.
2. Wind the antistatic cable around the blower
tube in a spiral (B, Fig.2) and insert it into the
hole in the blower tube; connect the end of
the antistatic cable B to the terminal in the
control handle (as shown in circle C, Fig.2).
3. Couple the blower tubes (13-14, Fig.1) and one
of the two curved terminals (15 or 16, Fig.1) by
GB
21